CONTROL AND DATA
| CATALOG ---
SERVICES --- CONTACT US----HOME
E-mail us to request more information on any of these products.
CONTROL AND DATA TECHNOLOGIES WILL MAKE YOUR PROJECT A SUCCESS.
|HIGH PERFORMANCE OPTO-ISOLATED SERIAL CARD PLCP0054 FOR ANALOG
DEVICES 6B MODULES
| CMOS DESIGN,
SOCKETED LINE DRIVERS HIGH RELIABILITY,
TECHNOLOGICALLY ADVANCED, CUSTOMIZABLE,
EVERY PART IS 100% TESTED AND BURNED-IN ,
COMPREHENSIVE HARDWARE AND SOFTWARE DOCUMENTATION,
FREE TECHNICAL SUPPORT.
ALL PARTS HAVE ONE YEAR WARRANTY
|The PLCP0054 High Performance Serial Card is an OPTO-ISOLATED RS-422 4-wire/ RS-485 2-wire serial port adapters. The Card has an onboard 200 mA DC/DC converter eliminating the need for an external power supply. This card is wired to communicate with the Analog Devices 6B series of data acquisition modules.|
FEATURESOpto-Isolated RS422 -RS485 Transfer rate up to 288,000 bit/sec.
Distances up to 1.2km (4000 ft.)
Enhanced onboard serial controller with: Independent TX and Rx FIFO's 4-bytes deep.
Two onboard 16.bit timers/counters
Two DB-9 connectors for networking 5,6,7,8, or 9 hits per data 0 to 2 stop bits, m 1I4-bit steps
Two loop-back modes Automatic echo of the received data (user enabled)
Onboard line termination resistors with easy access jumpers
Pull-up and Pull-down biasing resistors
Full COM1: and COM2: compatibility
Onboard 18.432MHz crystal oscillator
Fully PC compatible
Address may be set in any of the 8 bit boundaries of the 1024 I/O addresses
Card can be disabled with an optional external switch
On board optional opto-coupler and comparators for custom applications
Isolated and fused 5 volts power available at the 9 pin socket
APPLICATIONS- Industrial PC
- Noisy environments
- Network link-up
- Network with Analog Devices 6B Modules
|FOR MORE INFORMATION SEE PLPC0050 DATA SHEET|