{short description of image}

CONTROL AND DATA TECHNOLOGIES
ENGINEERING - DESIGN - SYNTHESIS
CDT THE "3Q COMPANY"™
QUALITY ENGINEERING - QUALITY DESIGN - QUALITY SERVICE
SINCE 1985
"CDT" AND "3Q COMPANY" ARE TRADE MARKS OF CONTROL AND DATA TECHNOLOGIES

CATALOG --- SERVICES --- CONTACT US----HOME
E-mail us to request more information on any of these products.





CONTROL AND DATA TECHNOLOGIES WILL MAKE YOUR PROJECT A SUCCESS.

HIGH PERFORMANCE OPTO-ISOLATED SERIAL CARD PLCP0052
 {short description of image}   CMOS DESIGN,
SOCKETED LINE DRIVERS HIGH RELIABILITY,
TECHNOLOGICALLY ADVANCED, CUSTOMIZABLE,
EVERY PART IS 100% TESTED AND BURNED-IN ,
COMPREHENSIVE HARDWARE AND SOFTWARE DOCUMENTATION,
FREE TECHNICAL SUPPORT.
ALL PARTS HAVE ONE YEAR WARRANTY

The PLCP0052 High Performance Serial Card is an OPTO-ISOLATED RS-422 4-wire/ RS-485 2-wire serial port adapters. The card has an onboard 200 mA DC/DC converter eliminating the need for an external power supply. The Card is equipped with a wait state generator to accommodate very high speed busses or low frequency oscillator. The onboard serial controller, an enhanced version of the industry standard 8250A UART allows for improved throughput. The on chip FIFO, and the extensive check done on the incoming characters, reduces the CPU overhead allowing baud rates unachievable with "standard" devices. The Card is designed to plug directly into a standard PC/PC-AT slot and will run all the standard software written for the PC.  

FEATURES

Opto-Isolated RS422 -RS485 Transfer rate up to 288,000 bit/sec.
Distances up to 1.2km (4000 ft.)
Enhanced onboard serial controller with: Independent TX and Rx FIFO's 4-bytes deep.
Two onboard 16.bit timers/counters
Separate clocking for the Tx and Rx machines 16 user-enabled Interrupt sources Supports for 9-bit microLAN network protocol Interrupt generation on address or control character matching
Two DB-9 connectors for networking 5,6,7,8, or 9 hits per data 0 to 2 stop bits, m 1I4-bit steps
Two loop-back modes Automatic echo of the received data (user enabled)
Onboard line termination resistors with easy access jumpers
Pull-up and Pull-down biasing resistors
Full COM1: and COM2: compatibility
Onboard 18.432MHz crystal oscillator
Fully PC compatible
Address may be set in any of the 8 bit boundaries of the 1024 I/O addresses
Card can be disabled with an optional external switch
On board optional opto-coupler and comparators for custom applications
Isolated and fused 5 volts power available at the 9 pin socket

 APPLICATIONS

- Industrial PC
- Noisy environments
- Network link-up
- High-speed communications
- High-speed data acquisition
- Program using more than one serial port simultaneously
- Network with programmable controllers
     
   FOR MORE INFORMATION SEE PLPC0050 DATA SHEET  
 

ORDERING:


PLCP0052: OPTO_ISOLETED RS-422/RS-488 WITH REPLACEABLE OSCILLATOR
 

1102051320